Jump to content

Leaderboard

  1. March 30 2024

    Mark Hershey

    Mark Hershey

    7 reputation points

    Rak

    Rak

    5 reputation points

    Ron

    Ron

    4 reputation points

  2. March 29 2024

    Ron

    Ron

    3 reputation points

    kassim akim

    kassim akim

    2 reputation points

    Glenn77

    Glenn77

    2 reputation points

  3. March 28 2024

    Ron

    Ron

    1 reputation point

    Nick Nicewonder

    Nick Nicewonder

    1 reputation point

    Andrew Brown

    Andrew Brown

    1 reputation point

  4. March 27 2024

    Ron

    Ron

    5 reputation points

    Derek RC Model Eng

    Derek RC Model Eng

    4 reputation points

    Andrew Brown

    Andrew Brown

    4 reputation points

  5. March 26 2024

    Linda Reynolds

    Linda Reynolds

    2 reputation points

    Andrew Brown

    Andrew Brown

    2 reputation points

    Mario Ronci

    Mario Ronci

    2 reputation points

  6. March 25 2024

    Andrew Brown

    Andrew Brown

    4 reputation points

    Ron

    Ron

    3 reputation points

    Derek RC Model Eng

    Derek RC Model Eng

    3 reputation points

  7. March 24 2024

    Derek RC Model Eng

    Derek RC Model Eng

    3 reputation points

    Ron

    Ron

    2 reputation points

    Klaus de Jong

    Klaus de Jong

    2 reputation points

  • Posts

    • Oyvind
      JDM

      By Oyvind · Posted

      Hi @JDM, usually within a week in the US. I responded in the other thread. 
    • Ron
      JDM

      By Ron · Posted

      @JDM, That's a good question to ask @Oyvind in the following post below. Short answer is (from what I've read), it depends on where you live, but Oyvind is great with responding to special instances, like if you live outside the US or Europe. Ron
    • JDM
      JDM

      By JDM · Posted

      I was wondering how long it would take to get my starter pack
    • Vincent Mitchell
      3D prints on a budget is ready

      By Vincent Mitchell · Posted

      @Ronald Guthrie Me too.  Unfortunately it interferes with the print quality a little so I won't be using it on prints I make for others.  The print head leaves  stringy artifacts because it has to retract and move out of camera range before he timelapse shot.  I have adjusted the print settings to minimize the effect, but I think it's about as good as it's going to get right now and there is still some stringy artifact material due to the head movement on timelapse.  It's easily removed, but the end product is not 100% smooth where the stringy filament is cut away.  Not horrible, but enough to where some folks may not like it.  If the part does not require asthetically pleasing exterior, I will definitely do a timelapse of the print though.  It's kind of cathartic, as was watching the defrag in windows 95.  😂😂😂
    • Ron
      3D prints on a budget is ready

      By Ron · Posted

      @Vincent Mitchell, Love the timelapse! I could watch that all day LOL! Ron
×
×
  • Create New...